Application of Cold Screed Plastic 

Cold plastic road paint
Cold plastic application


Step 1. Use a broom to clean the area you want to paint thoroughly. All oil, dust and old Thermo-plastic road paint must be removed.

Step 2. Use a chalk and measuring tape to outline the road marking to be painted.

Step 3. Use maskingtape to mark the outline of the paint/ marking, which could be an arrow, stop line or any other design.

Step 4. Pour hardener into LANINO Cold Screed Plastic at a ratio of 90g-100g : 5 liter . Using a mixing stick, mix the two components thoroughly for approximately 60 seconds.

Step 5. Pour LANINO Cold Screed Plastic onto the surface. Take care not to pour the product outside the maskingtape edges. Use a aluminium splinded roller or trowel to distribute the paint evenly. Ensure that the whole area is covered (1.5-3mm thick). Once finished, clean equipment with toluene. Do not add thinners to the paint as it will contaminate the paint.

Step 6. For retro-reflectivity, apply glass beads to the wet painted surface.

Step 7. Allow paint to cure for +/- 8 minutes. Carefully remove maskingtape. Allow to cure for +/- 30 minutes before opening to traffic. Drying time is influenced by road temperature and amount of hardener added.